Toll Free: 1.800.634.6659

Phone: (630) 443-4000

Fax: (630) 443-4140

Email: [email protected]

Questions & Inquiries

Contact Us

Fill out the contact form below and a member of our staff will be in contact with you during our regulars business hours.

Contact Page

  • This field is for validation purposes and should be left unchanged.
Dynamically Balanced
"A balance test was performed on the 2 x24 70mm spout hot runner manufactured by MDI. The calculations show that the system is 97% balanced with all tips at the same temperature."

John Tauber // Berry Plastics Corporation

Reliable Durability
"The 8 cavity mold from Melt Design was a custom tool built back in 2000. This tool runs 24x7x365 and has produced more than 40,000,000 pieces to date. The material we run is S.A.N. The MDI system has proven to be very reliable for us."

Bill Martz // Sun Star Inc.

Perfect Performance
"We re-tested the “LCP connector” mold which has the special nozzle from MDI. The nozzle performed perfectly and we achieved perfect parts. Your advice was absolutely correct and I thank you for the help. I declare this nozzle to be LCP approved."

John Tipton // Tipton Mold & Die Co.

Previous
Next
Over 35 years of experience

With over 25 patented products created in that time, we’re always looking to innovate.

Request A Quote

Enter your contact information below, and our staff will be in contact with you regarding this product promptly.

If there are any additional questions you have, feel free to include them in the message at the bottom of the form.

Request A Quote

  • This field is for validation purposes and should be left unchanged.